by Sam and Max
Introduction: This painting tutorial is written for boardgamers who want their playing pieces painted fast, don't want to spend much money, and are new to painting. It emphasizes "quick and dirty" techniques, so don't expect display-level results. I also did some experimenting, only sometimes with good results. So don't always follow what I did, and learn from my mistakes. If you read my previous painting tutorials, the mold lines and priming steps are (almost) the same.Goblin painting tutorial: http://boardgamegeek.com/thread/1144852/painting-tutorial-go...
Ettin painting tutorial:
http://boardgamegeek.com/thread/1140289/painting-tutorial-et...
Colors used:
* Secret Weapon Washes: Algae (zombie flesh)
* Secret Weapon Washes: Soft Body Black (general wash)
Speed and Newbie painting:
* Zenithal priming. See below. It's still about as fast as priming in one color.
* Paint the flesh light green.
* Paint the clothing light grey.
* Wash in Secret Weapon: Soft Body Black. This black wash seems to have some blue in it, resulting in an "organic" black that isn't as harsh as washing in a black wash made with ink or paint.
* Base as below.
Mold Lines: Mold lines are the "lines" of excess plastic on the miniature that should be cut off with a hobby knife, and filed off with small files. An engraving pen (under $10 at some craft stores) is a small handheld battery-operated "drill" with an industrial diamond-tipped head that will remove mold lines *much* faster. After removing mold lines, clean the figures in hot soapy water to remove the mold release agent, an oil. If you find mold lines after priming, you can still remove them. You can either spray white primer again, or use clear gesss (about $8 at craft stores) to paint over the plastic to "prime" the model for painting.
Zenithal Priming: To get the paint to stick to the plastic, spray the miniature with primer. Hardware stores sell spray primer, and make sure to purchase primer that says it will bond to plastic. When spraying primer, first clear the nozzle with a quick burst not aimed towards the miniature, then spray in sweeps starting a few inches to the side of the miniature. With zenithal priming, first completely prime the miniature black. Then lightly coat it in grey, then white, inspecting the miniature between sprays. You want the raised surfaces to be white, and recesses to be black. The black will give you a head start with shadows on the miniature, and the white areas will make highlights easier.
Note how the zenithal priming shows off the rib cage in the back.
Next: Washing!